Technical Data
Recommended Inside Bending Radii - Sheet and Plate - Alloys 5083 - 6061
Footnotes:
Bending transverse to rolling direction.
t=thickness in mm
1 Radii listed are minimum recommended for bending sheets and plates without fracturing in a standard press brake with air-bend dies. Other types of bending operations may require larger radii or permit smaller radii. The minimum permissable radii will also vary with the design and condition of tooling.
2 Heat-treatable alloys can be formed over appreciably smaller radii immediately after solution heat treatment.
3 The H112 temper (applicable to non-heat-treatable alloys) is supplied in the as-fabricated condition without special property control, but usually can be formed over radii applicable to the H14 (or H34) temper or smaller.
4 Applicable to 5005 H1X and H3X tempers.
Aluminium Castings - Aluminium Extrusions - Aluminium Finishes - Aluminium Ladders, Commercial - Building Products Division - Cladding, UlltraClad® - Decorative Metals - Download Brochures - Extruded Aluminium Bends - Manufactured Al Products - Fasteners - Marine Products - Sheet, Plate & Rollformed Aluminium - Welding Products - UlltraClad® Cladding -
Company Profile - Contact Details - Sales Centres - News - Home - TOP